It’s easy to assume that not much has changed with face mills for a while. There’s been so much attention on other milling processes over the last few years, and face mills, or shell mills, were ...

Roughing in progress. Despite interrupted cuts, the new Ingersoll-TEDI mill CD cartridge facemill plows through cast aluminum twice as fast as ICI tooling. In one of its first U.S. high-volume ...

Modern milling machines look much the same as they did 30 years ago. However, they now must cut superalloys, titanium, and high-tensile steels to closer tolerances and at faster rates than before. To ...

The bulk of the milling machine market consists of half-lane machines weighing from 60,000 to 90,000 pounds and typically equipped with roughly 7-foot-wide cutting drums, which are powered by 600- to ...

Milling machines, also known as cold planers, complete the same task today as they did 30 years ago, but they have seen several innovations over the years and are continuing to evolve. It was actually ...

The latest episode “Made in the USA” podcast explores a company that uses collaborative robots, one of the key tools helping US machine shops and other manufacturers compete with lower cost countries ...

The market for milling machines is on the upswing, not because of hope for a magical federal infrastructure package, but because of local efforts to shore up aging pavements. A relatively small amount ...